Under the sink, the fast fix
Every sink has two small valves under it, one hot and one cold. They stop water to that fixture without cutting the whole house. Turn each clockwise until it stops. If a valve is stiff, do not force it with a wrench, because a corroded stem can snap. In that case close the main shutoff and call us.
A valve that turns but does not stop the water is worn inside. That is a frequent finding in older homes, and it is a good moment to replace the valve while the water is off.
Common faucet and sink calls
Dripping spout
A worn cartridge, washer or seat lets water pass when the faucet is closed. The fix is a new internal part, not a new faucet in most cases.
Leak under the sink
Check the supply lines and drain connections. Braided supply lines can burst at the nut, and P-trap nuts loosen over time.
Handle that will not stop
A broken stem or cartridge keeps the valve open. The repair needs the supply shut off first.
Low flow from one tap
Mineral buildup in an aerator or a partly closed shutoff reduces flow. A cleaning or new cartridge restores it.
Fixture replacement versus parts
A faucet that is ten or fifteen years old may have discontinued parts, and chasing them can cost more than a new faucet. We tell you which way is cheaper and which will last. If you already bought a faucet, we install it. If not, we can guide you on mounting hole counts and kitchen versus bathroom styles.
Kitchen sinks add disposal and dishwasher connections, which is why a faucet swap sometimes reveals a loose drain fitting. Callers who also have a garbage disposal in the same cabinet should see the disposal repair page, since the two often fail together.
Supply line and valve condition
| Part | What we look for | Action |
|---|---|---|
| Shutoff valves | Stiff stems, drips at the packing nut, mineral crust | Replace if they do not seat cleanly. |
| Supply lines | Kinks, rust on fittings, bulging braided jackets | Replace on any fixture swap. |
| Drain trap | Damp nuts, cracked plastic, slow flow | Tighten or replace. |
| Faucet body | Corrosion at the base, wobbling handle | Replace the faucet if repair parts are gone. |
Can not shut a faucet off?
Close the main valve and call. We repair and replace around the clock.
East Hartford note: the water you are fixing for
Mineral buildup on fixtures depends on the water coming into the house. MDC publishes an annual Water Quality Report and runs a lab you can call with questions at (860) 278-7850, extension 3901. If your aerators clog quickly, ask what the report says about hardness before you choose new fixtures.
For any job where a valve is replaced behind a wall, confirm whether the East Hartford permit office wants a permit by calling (860) 291-7340.
Fixture connections, shutoffs and backflow protection at faucets and hose bibs fall under the International Plumbing Code (IPC). The 2022 Connecticut State Building Code adopts the 2021 IPC.
What affects the cost of faucet and sink repair
Faucet calls are usually quick.
Burst supply lines can cause large water damage. That damage may be covered by your policy while the failed line is not.
Common questions
Yes. A spraying supply line or a faucet that will not shut off can flood a room. The line is staffed around the clock.
The valve seat may be pitted or the cartridge may be worn. The repair needs the correct seat and cartridge for your model.
Yes. We install customer-supplied faucets and replace the supply lines and shutoffs at the same time if they are worn.
That fixture usually has a clogged aerator or a partly closed valve. If every tap is slow, look at the water heater or pressure. See water heater repair.
Yes. A bathtub valve needs the water shut off, and the cartridge or stem is replaced from inside the wall or through an access panel.
